Duerkopp Adler HP Series Additional guide Instrukcja Obsługi Pobierz pdf (Strona 73)

EFKA AB220A511173

Supplier Level

Code no. 311 with control operation

Code no. 3112 with control panel operation

Parameter Designation Unit max min Preset Ind.

271 PGr Number of angular degrees after the sensor degrees 255 0 180 *) A

position on the machine handwheel

272 trr Transmission ratio between motor shaft and machine 255 020 100 *) A

shaft (calculation formula see instruction manual!)

The transmission ratio should be determined and

indicated as precisely as possible!

273 Asi Signals M8, M9, M10 On/Off 1 0 0 A

(0 = Off, 1 = On)

274 Ad1 Delay time of signal M8 at the start of the seam ms 2550 **) 0 40 *) A

275 At1 ON period of signal M8 at the start of the seam ms 2550 **) 0 150 *) A

276 Ad2 Delay time of signal M9 at the start of the seam ms 2550 **) 0 50 A

277 At2 ON period of signal M9 at the start of the seam ms 2550 **) 0 60 A

278 Ad3 Delay time of signal M10 at the start of the seam ms 2550 **) 0 40 A

279 At3 ON period of signal M10 at the start of the seam ms 2550 **) 0 350 A

280 kd1 Delay time output M1 ms 2550 **) 0 0 *) A

281 kt1 ON period output M1 ms 2550 **) 0 100 *) A

282 kd2 Delay time output M2 ms 2550 **) 0 100 *) A

283 kt2 ON period output M2 ms 2550 **) 0 100 *) A

284 kd3 Delay time output M3 ms 2550 **) 0 200 *) A

285 kt3 ON period output M3 ms 2550 **) 0 100 *) A

286 kd4 Delay time output M4 ms 2550 **) 0 300 *) A

287 kt4 ON period output M4 ms 2550 **) 0 100 *) A

288 kdF Delay time until sewing foot On ms 2550 **) 0 380 *) A

289 kt5 ON period output M7 ms 2550 **) 0 1000 A

*) Depending on the selected mode. See table at the beginning of the List of Parameters!

**) When programming the 3-digit or 4-digit control parameter values (without control panel), the 2-digit or 3-digit

value displayed must be multiplied by 10.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 83 84

Brak uwag

Duerkopp Adler HP Series Additional guide Instrukcja Obsługi Strona 73