Duerkopp Adler HP Series Additional guide Instrukcja Obsługi Pobierz pdf (Strona 66)

EFKA AB220A5111

Technician Level

Code no. 190 with control operation

Code no. 1907 with control panel operation

Parameter Designation Unit max min Preset Ind.

196 StL Function “stitch lock” (parameter 290 = 21) 1 0 1 *) A

0 = Stitch lock Off

Output ST2/34 (STV) = Stitch condensing

1 = Stitch lock On

Output ST2/28 (M2) = Stitch condensing

Output ST2/34 (STV) = Stitch lock

Attention! Upon switching the parameter from 0 to 1 or

vice versa, the output function changes accordingly!

197 dr° Stop for thread trimming depending on angle degrees 720 0 0 *) A

198 SAk Functions with chainstitch machines 2 0 0 A

e. g. bag sewing machine (parameter 290 = 5)

0 = Function “thread trimming” or “hot thread chain

cutting” and sewing foot lift using the pedal.

1 = Function “thread trimming” or “hot thread chain

cutting” by means of knee switch and sewing foot lift

using the pedal.

2 = Function “thread trimming” or “hot thread chain

cutting” using the pedal and sewing foot lift by means

of knee switch.

199 FSn 0 = Thread tension release On at the seam end until 2 0 0 *) A

pedal in pos. 0 (neutral).

1 = Thread tension release On at the seam end or at

the start of the seam.

2 = As with setting 1, but thread tension release

is enabled immediately after “power on“.

This parameter is effective only in the overlock mode!

*) Depending on the selected mode. See table at the beginning of the List of Parameters!

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 83 84

Brak uwag

Duerkopp Adler HP Series Additional guide Instrukcja Obsługi Strona 66