Duerkopp Adler HP Series Additional guide Instrukcja Obsługi Pobierz pdf (Strona 68)

EFKA AB220A5111

Supplier Level

Code no. 311 with control operation

Code no. 3112 with control panel operation

Parameter Designation Unit max min Preset Ind.

237 tkS Switch-off delay for chain suction at the ms 2550 **) 0 0 A

seam end, if parameter 022 = 2.

238 EnP Software debouncing for all inputs: 1 0 1 A

0 = No debouncing

1 = With debouncing

239 FEL Selection of the input function on socket B18/5 47 0 0 A

0 = Light barrier function, if 009 = 1

All other functions as with parameter 240.

240 in1 Selection of the input functions on socket ST2/7 47 0 0 *) A

for input 1

0 = No function

1 = Needle up/down

2 = Needle up

3 = Single stitch (basting stitch)

4 = Full stitch

5 = Needle to position 2

6 = Machine run blockage effective with open

contact

7 = Machine run blockage effective with closed

contact

8 = Machine run blockage unpositioned effective

with open contact

9 = Machine run blockage unpositioned effective

with closed contact

10 = Automatic speed n12 without pedal

11 = Limited speed n12 pedal controlled

(see parameter 266)

12 = Sewing foot lifting with pedal in position 0

(neutral)

13 = High lift for walking foot with speed limitation n10

(operational mode not stored)

14 = High lift for walking foot (flip-flop 1) with speed

limitation n10

15 = Tape cutter / fast scissors: function only in

chainstitch and overlock mode

16 = Intermediate backtack / intermediate stitch

condensing

17 = Stitch regulator suppression / recall

18 = Unlocking the chain: can be activated by

keystroke, but will be executed only at the

seam end

19 = Reset bobbin thread monitor if parameter

030 = >0

20 = Handwheel running in the direction of rotation

according to the setting of parameter 161

21 = Handwheel running in the opposite direction of

rotation according to the setting of parameter

161

22 = Speed limitation n11 (flip-flop 2). Output

ST2/29 is enabled according to setting of

parameter 186

23 = No function

24 = No function

25 = Speed limitation with ext. potentiometer

On/Off (see parameter 126)

26 = Manual stacker

27 = Unlocking the chain, function is performed

upon pressing the key

28 = External light barrier (according to the

setting of parameter 131)

*) Depending on the selected mode. See table at the beginning of the List of Parameters!

**) When programming the 3-digit or 4-digit control parameter values (without control panel), the 2-digit or 3-digit

value displayed must be multiplied by 10.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 83 84

Komentarze do niniejszej Instrukcji

Brak uwag

Duerkopp Adler HP Series Additional guide Instrukcja Obsługi Strona 68

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Maszyny do szycia Duerkopp Adler HP Series Additional guide